Difference between revisions of "2008 July RFA Experiment Georgetown"

From NAMIC Wiki
Jump to: navigation, search
Line 16: Line 16:
 
*Do RFA phantom experiment on 07/30.
 
*Do RFA phantom experiment on 07/30.
 
*Work on the IGSTK/OpenIGTLink/Slicer interface for sending the transforms so that a working example may be built that sends transforms from IGSTK to Slicer and that this program is configurable, supporting all of the IGSTK trackers.
 
*Work on the IGSTK/OpenIGTLink/Slicer interface for sending the transforms so that a working example may be built that sends transforms from IGSTK to Slicer and that this program is configurable, supporting all of the IGSTK trackers.
 +
**Patient to image registration (using Landmarks) in Slicer?
 
*Hammer out the details of how to communicate a segmentation performed in slicer to the path planning component and then upload the plan back to Slicer.  
 
*Hammer out the details of how to communicate a segmentation performed in slicer to the path planning component and then upload the plan back to Slicer.  
 
*It would be nice to create stubs that allow us to go through the whole workflow in Slicer so that we have an initial module into which the actual content can be added later.
 
*It would be nice to create stubs that allow us to go through the whole workflow in Slicer so that we have an initial module into which the actual content can be added later.
  
 
=Results=
 
=Results=

Revision as of 02:38, 24 July 2008

Home < 2008 July RFA Experiment Georgetown

Date: July 30 - August 1, 2008

Location: Imaging Science and Information Systems (ISIS) Center, Department of Radiology, Georgetown University Medical Center, 2115 Wisconsin Avenue, Suite 603, Washington, DC, 20007

Participants

  • Kevin Cleary
  • Ziv Yaniv
  • Filip Banovac
  • Noby Hata
  • Haiying Liu

Schedule

Wednesday (7/30): Phantom experiment will start around 5pm if all goes well.

Agenda

  • Do RFA phantom experiment on 07/30.
  • Work on the IGSTK/OpenIGTLink/Slicer interface for sending the transforms so that a working example may be built that sends transforms from IGSTK to Slicer and that this program is configurable, supporting all of the IGSTK trackers.
    • Patient to image registration (using Landmarks) in Slicer?
  • Hammer out the details of how to communicate a segmentation performed in slicer to the path planning component and then upload the plan back to Slicer.
  • It would be nice to create stubs that allow us to go through the whole workflow in Slicer so that we have an initial module into which the actual content can be added later.

Results