UNC 2015

From NAMIC Wiki
Jump to: navigation, search
Home < UNC 2015

[Page under construction]

Introduction

The 3D Slicer UNC workshop is a full day course that will combine a series of lectures and hands-on sessions using the 3D Slicer software. The morning session will provide an introduction to the basics of data loading, 3D visualization and image registration. The afternoon session will focus on fundamental and practical aspects of Diffusion MRI analysis.

Workshop Organizers

  • Sonia Pujol, Ph.D., Brigham and Women's Hospital, Harvard Medical School
  • Martin Styner, Ph.D., University of North Carolina at Chapel Hill

Local Host

  • Martin Styner, Ph.D., University of North Carolina at Chapel Hill

Tentative Agenda

  • 9:00-9:15 am Computer setup assistance by the instructors
  • 9:15-9:30 am Welcome and Goals of the Workshop (Martin Styner)
  • 9:30-10:00 am Introduction to the 3D Slicer software and community (Sonia Pujol)
  • 10:00-11:00 am Hands-on session 1: 3D Data Loading and Visualization (partI) (Sonia Pujol)
  • 11:00-11:15 am Coffee break
  • 11:15-12:15 pm Hands on session2: Image registration (Sonia Pujol)
  • 12:15-1:30 pm Lunch
  • 1:30 pm-2:15 pm An Introduction to Diffusion Tensor Imaging (Sonia Pujol)
  • 2:15 pm-2:45 pm The DTI Prep Tool (Martin Styner/Francois Budin)
  • 2:45 pm -3:00 pm Coffee Break
  • 3:00-3:45 pm White Matter exploration for Neurosurgical Planning (Sonia Pujol)
  • 3:45-4:30 pm 3D Slicer UNC demos (Martin Styner/Francois Budin) using DTI-Reg, FiberViewerLight and DTIAtlasFiberAnalyzer
  • 4:30-5:00 pm Questions from the audience and concluding remarks

Logistics