IGT:ToolKit/Build-IGSTK

Back to IGT:ToolKit

1. In directory igt-tutorial, download IGSTK source code by running these commands:

cvs -d :pserver:anonymous@public.kitware.com:/cvsroot/IGSTK login
 answer by 'igstk'
cvs -d :pserver:anonymous@public.kitware.com:/cvsroot/IGSTK co IGSTK
cvs -d :pserver:anonymous@public.kitware.com:/cvsroot/IGSTK co IGSTKSandbox

2. Build IGSTK

• In directory igt-tutorial, create a new directory IGSTK-build.
• Cd IGSTK-build, configure the project

ccmake ../IGSTK

3. Build IGSTKSandbox

• In directory igt-tutorial, create a new directory IGSTKSandbox-build.
• Cd IGSTKSandbox-build, configure the project

ccmake ../IGSTKSandbox

You need to set Slicer3_DIR as the build directory of Slicer3, i.e. Slicer3-buld. Also, make sure you have version 2.6 of CMake installed. If you don't, you can find in Slicer3-lib/CMake-build/bin. After configuration, run

make 

To build OpenIGTLink. Upon completion, you should find libOpenIGTLink.so here at igt-tutorial/OpenIGTLink-build/lib/Slicer3/Modules.