Home < 2014 Summer Project Week:Longitudinal patient specific DTI analysis
- Utah: Anuja Sharma, Guido Gerig
- UNC: Francois Budin, Martin Styner
- Patient specific modeling of longitudinal changes in white matter tract integrity for a neonate with basal ganglia injury (as compared with an age matched control neonate subject).
- We will be using DICOM/DWI/DTI modules available as a part of Slicer for a majority of the steps - starting from raw DICOM data up to the assessment of the fiber tract diffusion profiles.
- Multiple time points from both the subjects would be co-registered to enable a comparative analysis.
- An initial attempt at processing the complete pipeline is completed for a single subject with basal ganglia injury and a control subject.
- Slicer modules were used to create an end-to-end processing solution. Some of the steps required command line software utilities and are mentioned in detail below.
Patient-specific longitudinal DTI analysis
The data consisted of four longitudinal scans for each subject: day 1, day 2, day 10 and day 30 (after birth). Here we briefly outline the sequential steps that were followed for the analysis:
- DICOM to DWI conversion using Slicer's DWIConvert.
- DWI Quality control using DTI Prep. A few bad gradient directions were removed as well as artifacts like motion correction were taken care of. Most of the artifacts that caused an exclusion were Venetian blinds or random high intensity slices.
Bad gradient direction in one of the DWI images-removed using DTI Prep
A case of high intensity slice artifact-removed using DTI Prep
- Mask generation for DWI. The otsu mask created using Slicer module contained holes that required manual editing. It also contained the eyes which had to be manually edited out. Therefore, for this step we used the command line brain extraction tool instead.
Mask generated using otsu threshold
Mask from the brain extraction tool
- DWI to DTI conversion using Slicer. We also performed a sanity check by overlaying glyphs and performing an approximate full brain tractography at this stage.
- Considering the non-linear speed at which early neurodevelopment occurs, we chose day 30 as our reference time point for co-registering all other timepoints. Relatively, the brain shows the maximum structuring possible within a span of one month after birth. Therefore, all other timepoints were registered to the day 30 image of the control subject. DWI baseline images were used for the registration and the transforms obtained were used to resample to corresponding DTI images. After this step, images from all the timepoints, from both the subjects are in the same space.
Control subject: Transformed Day 1 DTI overlaid with Day 30 FA image of the control subject
Basal Ganglia subject: Transformed Day 10 DTI overlaid with Day 30 FA image of the control subject
- A label map based ROI is created for the posterior internal capsule tract due to its proximity to the basal ganglia region of the brain. Tractography provides fiber tract definitions from all DTI images. Since the images are co-registered, ROI is defined only one in the space of the control's day 30 image and applied without change to all other timepoints for both subjects.
- Longitudinal diffusion profiles from both subjects can now be compared to assess white matter abnormalities owing to the injury. An arc length parametrization scheme allows us to extract the cross sectional scalar diffusion properties along the length of the tract.
- Comparison of diffusion profiles along the tract's length indicate a delayed white matter development in the posterior internal-capsule tract during the first month after birth (when compared with an age matched control subject).
FA diffusion profiles at time point day-1 for both the subjects.
FA diffusion profiles at time point day-10 for both the subjects.
- Future work includes a better atlas creation scheme to avoid bias introduced by using a specific image as a reference frame. The fiber tract geometry needs to stay consistent for an accurate comparison. This can be achieved by retaining the atlas tract geometry and assembling diffusion properties from the individual images using the image-to-atlas transformations without actually warping the tract geometry for each individual case.
- As a next step, we intend to continuously model the longitudinal change of cross-sectional distributions of diffusion properties instead of the average diffusion profiles. The change of distribution along time can provide a richer framework to identify areas of significant differences.
- A.R. Verde, F. Budin, J.-B. Berger, A. Gupta, M. Farzinfar, A. Kaiser, M. Ahn, H. Johnson, J. Matsui, H.C. Hazlett, A. Sharma, C. Goodlett, Y. Shi, S. Gouttard, C. Vachet, J. Piven, H. Zhu, G. Gerig, M. Styner. “UNC-Utah NA-MIC framework for DTI fiber tract analysis,” In Frontiers in Neuroinformatics, Vol. 7, No. 51, January, 2014.
- A. Sharma, P.T. Fletcher, J.H. Gilmore, M.L. Escolar, A. Gupta, M. Styner, G. Gerig. “Spatiotemporal Modeling of Discrete-Time Distribution-Valued Data Applied to DTI Tract Evolution in Infant Neurodevelopment,” In IEEE Proceedings of ISBI 2013.
- A. Sharma, P.T. Fletcher, J.H. Gilmore, M.L. Escolar, A. Gupta, M. Styner, G. Gerig. “Parametric Regression Scheme for Distributions: Analysis of DTI Fiber Tract Diffusion Changes in Early Brain Development,” In Proceedings of the 2014 IEEE International Symposium on Biomedical Imaging (ISBI), pp. (accepted). 2014.
- A. Sharma, S. Durrleman, J.H. Gilmore, G. Gerig. “Longitudinal Growth Modeling of Discrete-Time Functions with Application to DTI Tract Evolution in Early Neurodevelopment,” In Proceedings of IEEE ISBI 2012, pp. 1397--1400. 2012.
- C.B. Goodlett, P.T. Fletcher, G. Gerig, et al., “Group analysis of dti ﬁber tract statistics with application to neurodevelopment,” Neuroimage, vol. 45, no. 1, pp. S133–S142, 2009.