Difference between revisions of "IGT:ToolKit/Build-IGSTK"
From NAMIC Wiki
(New page: Back to IGT:ToolKit 1. In directory '''igt-tutorial''', download OpenIGTLink module source code by running this command: svn co http://www.na-mic.org/svn/NAMICSandBox/...) |
|||
| Line 1: | Line 1: | ||
Back to [[IGT:ToolKit|IGT:ToolKit]] | Back to [[IGT:ToolKit|IGT:ToolKit]] | ||
| − | 1. In directory '''igt-tutorial''', download | + | 1. In directory '''igt-tutorial''', download IGSTK source code by running these commands: |
| − | + | cvs -d :pserver:anonymous@public.kitware.com:/cvsroot/IGSTK login | |
| + | answer by 'igstk' | ||
| + | cvs -d :pserver:anonymous@public.kitware.com:/cvsroot/IGSTK co IGSTK | ||
| + | cvs -d :pserver:anonymous@public.kitware.com:/cvsroot/IGSTK co IGSTKSandbox | ||
| + | |||
2. In directory '''igt-tutorial/IGTLoadableModules''', create a new directory '''OpenIGTLink-build''' | 2. In directory '''igt-tutorial/IGTLoadableModules''', create a new directory '''OpenIGTLink-build''' | ||
Revision as of 15:52, 26 May 2008
Home < IGT:ToolKit < Build-IGSTKBack to IGT:ToolKit
1. In directory igt-tutorial, download IGSTK source code by running these commands:
cvs -d :pserver:anonymous@public.kitware.com:/cvsroot/IGSTK login answer by 'igstk' cvs -d :pserver:anonymous@public.kitware.com:/cvsroot/IGSTK co IGSTK cvs -d :pserver:anonymous@public.kitware.com:/cvsroot/IGSTK co IGSTKSandbox
2. In directory igt-tutorial/IGTLoadableModules, create a new directory OpenIGTLink-build
3. Cd to OpenIGTLink-build, and run the following command to configure the project:
ccmake ../OpenIGTLink
You need to set Slicer3_DIR as the build directory of Slicer3, i.e. Slicer3-buld. Also, make sure you have version 2.6 of CMake installed. If you don't, you can find in Slicer3-lib/CMake-build/bin. After configuration, run
make
To build OpenIGTLink. Upon completion, you should find libOpenIGTLink.so here at igt-tutorial/OpenIGTLink-build/lib/Slicer3/Modules.
